New Error

  • Weiler810T
  • Topic Author
  • New Member
  • New Member
More
7 years 3 months ago #138725 by Weiler810T
New Error was created by Weiler810T
I updated Gmoccapy and there came the new error message, what the hell is this ?
Info: LINUXCNC - 2.9.0-pre0-217-g9948f41b4 Gmoccapy 2.3.5

Attachment not found

Please Log in to join the conversation.

More
7 years 3 months ago #138729 by phillc54
Replied by phillc54 on topic New Error
That was fixed earlier today, you will need to update again.

Please Log in to join the conversation.

More
7 years 3 months ago #138745 by pl7i92
Replied by pl7i92 on topic New Error
lots of changes going on now
is there a side where this is documented
bugfixes and more

Please Log in to join the conversation.

More
7 years 3 months ago #138764 by phillc54
Replied by phillc54 on topic New Error
For current issues

For closed issues

Please Log in to join the conversation.

  • Weiler810T
  • Topic Author
  • New Member
  • New Member
More
7 years 3 months ago #138776 by Weiler810T
Replied by Weiler810T on topic New Error
Proplem solved :)
Next Proplem is : 3 Achtung: Fehler X-Achse!joint 0 following error
emc/task/taskintf.cc 942: Error on joint 0, command number 233

What is that ?:unsure:

Please Log in to join the conversation.

More
7 years 3 months ago #138787 by newbynobi
Replied by newbynobi on topic New Error
following error = Schleppfehler
You joint / axis can not follow the commanded movement due to acceleration or speed isue.

Nothing to do with gmoccapy

Norbert

Please Log in to join the conversation.

  • Weiler810T
  • Topic Author
  • New Member
  • New Member
More
7 years 3 months ago #138790 by Weiler810T
Replied by Weiler810T on topic New Error
Servus Norbert

Yes, I know, but what asserts command number 233 ?

Siggi

Please Log in to join the conversation.

More
7 years 3 months ago #139165 by andypugh
Replied by andypugh on topic New Error
I think that is line 233 in the G-code file.

Please Log in to join the conversation.

  • Weiler810T
  • Topic Author
  • New Member
  • New Member
More
7 years 3 months ago #139232 by Weiler810T
Replied by Weiler810T on topic New Error
I think that's a bug that can be replicated.This only happens after the reference run. If I start a program afterwards, the error message appears. If I move the axis by hand and then start the program, the machine runs for hours without error. :unsure:


Siggi

Please Log in to join the conversation.

More
7 years 3 months ago #139428 by andypugh
Replied by andypugh on topic New Error

Weiler810T wrote: I think that's a bug that can be replicated.This only happens after the reference run. If I start a program afterwards, the error message appears. If I move the axis by hand and then start the program, the machine runs for hours without error.


This sounds very strange Can you confirm what you mean by "reference run" and "move the axis by hand"

Please Log in to join the conversation.

Time to create page: 0.102 seconds
Powered by Kunena Forum