Hi,
I'm following this manual page :
linuxcnc.org/docs/2.7/html/gui/gmoccapy.html#_tool_related_pin
In [strike].ini[/strike].hal file I made this modification (gmoccapy lines are copy/paste form documentation) :
Code:
loadusr -W hal_manualtoolchange
#net tool-change iocontrol.0.tool-change => hal_manualtoolchange.change
#net tool-changed iocontrol.0.tool-changed <= hal_manualtoolchange.changed
#net tool-number iocontrol.0.tool-prep-number => hal_manualtoolchange.number
#net tool-prepare-loopback iocontrol.0.tool-prepare => iocontrol.0.tool-prepared
net tool-change gmoccapy.toolchange-change <= iocontrol.0.tool-change
net tool-changed gmoccapy.toolchange-changed <= iocontrol.0.tool-changed
net tool-prep-number gmoccapy.toolchange-number <= iocontrol.0.tool-prep-number
net tool-prep-loop iocontrol.0.tool-prepare <= iocontrol.0.tool-prepared
Finally I get this error :
Code:
Pin 'gmoccapy.toolchange-change' does not exist
What's wrong in my [strike]ini[/strike]hal file and/or the documentation ?
