Tool change problem probe not detected (solved)

My suspicion is something is not correct in the remap. Could this be an issue in my post processor? What should the lines be for tool change, this is what Is in mine.

Please try

[TOOLSENSOR]
X = 47
Y = 1
Z = -4
MAXPROBE = -3

And report.
Z pos plus maxprobe should not be greater than max z travel.

Norbert

Toolchange command should be something like this

G40
G49
T1 M6
G43
S3600 M3
M8

Norbert

I cannot thank you enough, That was it.
Why did I not get that?

Norbert
I have to say for me this has been a very productive but frustrating learning experience.
Thank you for clearing up my ignorance on this issue. And for all the hard work you put into Gmoccapy and linuxcnc

You are welcome!

Norbert