I think it hates me.

Was going to run a part and started the system up and this is what i get after login.



it willl not let me start any instance of linuxcnc Gmoccapy or axis it says linuxcnc is running do i want to restart and when i do it gives this DBUG info



I think it hates me.

Ok I guess never mind after about an 30 mins of reboots and unplugging everything and numerous restarts it has decided to grant me a little machine time.

Odd.

The problem was that LinuxCNC was still running. This sometimes happens if LinuxCNC crashes, it can leave the realtime modules loaded. There isn't an easy way to unload them as they are mutually dependent. But a PC restart always works.

The question is, what caused the initial crash that caused the module tangle?