Gmoccapy Jog Buttons Dissappears With Dual Axis Joint

Linux 2.9 pre.

I've noticed that if I set up a basic config using pncconf, that if the config is using a tandem motor axis that the jog buttons won't be available in the gmoccapy gui. If I make the same config, this time just leaving out that tandem joint, the jog buttons appear on screen as expected.

Same here I just upgraded to master branch got things set up, started Gmocappy, and no jog buttons.

Duh!
What was I thinking.
Been up to long.

Gaunt1969 wrote: Duh!
What was I thinking.
Been up to long.

???????????????????

Tommy
When I was upgrading my system to master, after I started gmoccapy and seen the same issue agent did. It did not dawn on me how linuxcnc was treating each motor as a separate joint and required a home befor it would dispay the buttons.
I had been working on this thing to long

Thank you for explaining that.