Code:
#============================================================
#---SPINDLE-OVERRIDE-POT---START---
net spindle-analogue hm2_7i92.0.7i77.0.0.analogin1 => spindle-scale.in
net spindle-override spindle-scale.out halui.spindle.0.override.scale
setp halui.spindle.0.override.counts 1
setp halui.spindle.0.override.direct-value 1
setp spindle-scale.gain 4.18
#===POT INPUT IS LINEAR 0-23.915v===
setp spindle-scale.offset 0
#---SPINDLE-OVERRIDE-POT---END---
#============================================================
Looking here I see you are using direct value but counts is hard coded to 1.
counts is how you adjust the rate.
counts * scale = SO percentage
You also seem to have a second scale component - halui.spindle.0.oveeride has it's own scale setting
Chris
