Change blockheight without reprobing?

More
6 years 7 months ago #158964 by ahhkoch
Change blockheight without reprobing? was created by ahhkoch
Hi,

my situation is often: I change the workpiece, but not the tool.
Can i change the blockheigt without doing a tool measurement again? Or is tool-Offset only calculated when doing tool measurement?

Greetings

Please Log in to join the conversation.

More
6 years 7 months ago #158978 by bbsr_5a
Replied by bbsr_5a on topic Change blockheight without reprobing?
just set the Touchoffpoint to the heigher value

move by MDI the mesured value higher and give it the old value
by touchoff G54

Please Log in to join the conversation.

Time to create page: 0.074 seconds
Powered by Kunena Forum