Doku: Gmoccapy jog increment pins names

More
5 years 10 months ago #190906 by RotarySMP
Doku: Gmoccapy jog increment pins names was created by RotarySMP
Hi Norbert,

There is a small error in the gmoccapy doku... on my machine these pins :
Code:
5.5. Jog Increment Hal Pins The jog increments are selectable through hal pins, so a select hardware switch can be used to select the increment to use. There will be a maximum of 10 hal pin for the increments given in the INI File, if you give more increments in your INI File, they will be not reachable from the GUI as they will not be displayed. If you have 6 increments in your hal you will get 7 pins: gmoccapy.jog-inc-0

... are gmoccapy.jog.jog-inc-x

I like this interface more and more, as I use it. Brilliant york you did on it.
Mark

Please Log in to join the conversation.

More
5 years 10 months ago #190907 by newbynobi
Replied by newbynobi on topic Doku: Gmoccapy jog increment pins names
Thanks for the hint, I will check that one, I thought I did correct that one. May be you have the older docu?

Norbert

Please Log in to join the conversation.

More
5 years 10 months ago #190940 by RotarySMP
Replied by RotarySMP on topic Doku: Gmoccapy jog increment pins names
Hi Norbert,
I googled gmoccapy, and the first link which comes up is dated "Last updated 2020-08-21 06:34:58 MDT"

This still has the single jog.
Mark

Please Log in to join the conversation.

More
5 years 10 months ago #190962 by rodw
Replied by rodw on topic Doku: Gmoccapy jog increment pins names

RotarySMP wrote: Hi Norbert,
I googled gmoccapy, and the first link which comes up is dated "Last updated 2020-08-21 06:34:58 MDT"

This still has the single jog.
Mark


I have been caught so many times googling up obsolete documentation, I always go to the main docs page and find what I want from the menus.

I might use google for gcode or mcode syntax but thats it.

Please Log in to join the conversation.

More
5 years 10 months ago #190963 by RotarySMP
Replied by RotarySMP on topic Doku: Gmoccapy jog increment pins names
Going in through the doc top level and then to 2.8 ( or 2.9) returns the corrected versions. Sorry. I didn't realise that the Docu is completely rereleased wit each version release. Thanks.
Mark

Please Log in to join the conversation.

Time to create page: 0.088 seconds
Powered by Kunena Forum