Help setting up/troubleshooting gmocappy on site Schleswig/Holstein home kiel

I am looking for help on site when setting up or troubleshooting gmocappy
Of course,for expense allowance.Control rus so far.Axes run references run. tool lenght measurement worked until recently.
After switching on the control and gmocappy,various error messages apper.
Since I am with the device Stand at war and am not a rocket technican,i would be very happy if
someone was in the schleswig-holstein area kiel agree to help me.

Best tegards

What about TeamViewer?
I am in Hildesheim.

Norbert

Hello Norbert

when i select a tool from the list ,an error message appears.

The following debugs are in the macros/change ngc folder.

what can i do?

Did you change the code? The error tells you, that there is an O used in line 2, so if you have changed line 1 the error could also be reported at line 2.

There has been also a problem with case sensitive o-word stuff, may be you just try to change AL uper o calls to lower letter calls.

Norbert

i haven't changed anything.

which settings are correct?

the sensor of the WZLS was defective.i exchanged it for a new one,the sensor is now working properly.

could have something to do with it?

IMHO not.
Did you update some time ago?
Have you tried changing the O's in the file from upper to lower?

Norbert

Hello Norbert
happy Easter

i have changed the O,s to lower. Now the WZLS is working. thank you for your help.

when i loade a test milling job i get an error message.can you please have a look at that.

Thomas

First error: You did not touch off in Z, axis 2 and the code does contain a movement what would excide the limits, so on a machine with 100 mm travel distance you try to move to 120

Second error: invalid parameters just check that line and the one above and the following one for typos

Third error no subroutine on aboard found, check typos, seems to be a wrong entry in your INI file or the subroutine path is wrong or...

Why do you use on aboard? Most times it is not necessary, and apologize, you seems to miss basic knowlage, so you might just have on aboard in your inin, because you read it in a docu or so.

Norbert

Hello Norbert

thank you first for your patience. as you have already seen, ido not have enough basic knowledge.
i`am already happy to have got the machine running
in addition,i only have simple school english and have to understand many technical terms first
please explain to me exactly what i did wrong and what exactly i have to do for the machine to do a milling job

Thomas