Reset

So I looked around here and couldn't find it, I'm using Gmoccapy interface and I would like to use an external “Reset” button, as in industrial machines, I've already reserved an “in-02” entry.  I intend to use it to remove faults, alarm messages from the system and that I also created (ex.: oillow, airlow, etc…).  I've tried with the “halui.abort” function but I wasn't successful, does anyone have any idea about it?

Try this:
net delete-messages <= ..in-02 => gmoccapy.delete-message

I did the test as you indicated and the following message appears: “gmoccapy.delete-message” does not exist

Make sure you place that in the postgui_hal as the pins are only created after gmoccapy is loaded.

Documentation:
linuxcnc.org/docs/html/gui/gmoccapy.html