Ignore limits does not work on start up

Hi,

when I turn on the machine and the machine sits on limit switch, the Ignore limits check box cannot be toggled.

When I hit limit switch during normal operation after machine is homed and stuff I can use Ignore limits without problems.

Is this expected behaviour?

Thanks
Jiri

I thought I corrected that bug already
What release do you use?

What if you toggle the e-stop switch?

Norbert

A fix is provided here: github.com/LinuxCNC/linuxcnc/pull/1453

Sorry,
I was using the version before fix.

Thank you.
Jiri

No worries, you couldn't know that - it's still an open pull request. But it would be nice if you could tell us if this works for you.