Rotary Jog Speed

Hello everyone..

I am using step config wizard with XYZA machine. Software 2.8.2 buster.

Now when I put A axis speed value in step-config, it is in degree/sec. I put 56 degree/s i.e 9.33 rpm and testing the axis rotates in that speed.

But during use in GMOCAPPY, the same value shows with degree/min at max jog speed i.e 56 degree/min (0.16 RPM) which is very slow in fact.

How to solve??

can you post your config files?

Attached

Try changing these values in your iNI file:

[DISPLAY]
...
DEFAULT_ANGULAR_VELOCITY = 5.60
MIN_ANGULAR_VELOCITY = 0
MAX_ANGULAR_VELOCITY = 56.00

(I am a bit puzzled, in that going by the date in the INI file, you have been putting up woth this for three years?)

the motherboard has some issue with the battery, date is not stored