Spindle Load feedback in Gmoccapy

net bar_spindle_load spindle_load.bar_spindle_load should work

 

Hi ChironFZ16,

I don't understand what you are trying to tell me with your post.

My problem is that the command:
EMBED_TAB_COMMAND = gladevcp -x {XID} spindle_load.glade -H connect-pin.hal
ignores the connect-pin.hal file.

What should happen if you change the name of the signal:
net bar_spindle_load      spindle_load.bar_spindle_load
net signal-spindle-load   spindle_load.bar_spindle_load
?

Have you tried this test forum.linuxcnc.org/gmoccapy/45856-spindl...capy?start=20#266183 ?
If you tried that test, did you see a signal bar_spindle_load  or signal-spindle-load in halshow=>Signals?

It would help me if you did the test too so we know it's not my fault.

I have started a trial and it seems to work

 

Show Signals please not Pins.

So, the signal " signal-spindle-load" is not present here

 

Should I make an Issue on Github?

There are several sample configs which are showing how the -H option works.
I suggest you try those and compare them with your configuration.

For example:

If that does not lead to success you are welcome to post your configuration.

I found problem:

This works:
This NOT works:

Sorry for the complications, I didn't know that the order there is important. But nice that it works now.