Error when creating new program

More
4 years 1 month ago #252482 by macsddau@linuxcnc
Error when creating new program was created by macsddau@linuxcnc
Got an error while creating a new program :
 

Attachment not found


Using new linuxcnc-uspace-rtai_2.8.4_amd64

Please Log in to join the conversation.

More
4 years 1 month ago #252486 by HansU
Replied by HansU on topic Error when creating new program
Can you post your config or does this also appear on a sample config for you?
I cannot reproduce this.

Please Log in to join the conversation.

More
4 years 1 month ago #252492 by macsddau@linuxcnc
Replied by macsddau@linuxcnc on topic Error when creating new program
.ini & .hal attached

Please Log in to join the conversation.

More
4 years 1 month ago #252527 by HansU
Replied by HansU on topic Error when creating new program
You found a little bug in Gmoccapy.
This happens if you don't have an entry for "RS274NGC_STARTUP_CODE" in the INI file.

You can avoid this by providing some startup code like
Code:
[RS274NGC] RS274NGC_STARTUP_CODE = G90
or just a comment
Code:
[RS274NGC] RS274NGC_STARTUP_CODE = (a comment)

Please Log in to join the conversation.

More
4 years 1 month ago #252531 by macsddau@linuxcnc
Replied by macsddau@linuxcnc on topic Error when creating new program
Added the required line with some G codes. Works fine.
Thank you HansU

Please Log in to join the conversation.

Time to create page: 0.078 seconds
Powered by Kunena Forum