Disable manual tool change dialog

Hello,

simple question. How I can disable manual tool change dialog in gmoccapy 3.1.3.8?
Im using my own M6 and random tool changer. I have 2 machines one using linuxcnc 2.7 one 2.8.
Code and configuration is same but at 2.8 lcnc is showing this dialog.
I can send hal, ini no problem.

 

I guess it's done with disconnecting these pins: linuxcnc.org/docs/2.9/html/gui/gmoccapy.html#_tool_related_pins

Yes that was first that I check.
Problem is that I dont using this pin in hal. So I think all pins is disconncted.
Another problem is I dont see gmoccapy.toolchange-confirm pin.
Misterious are that I click to gmoccapy.toolchange-change pin in halshow. I see toolchange-change and toolchange-changed pin.

 

 

Yes that was first that I check.
Problem is that I dont using this pin in hal. So I think all pins is disconncted.

Sure? Also not in the postgui-halfile? They are connected there by default.
If those pins are not connected, Gmoccapy won't pop up that dialog.

Another problem is I dont see gmoccapy.toolchange-confirm pin.

That's probably because I linked to the 2.9 documentation, sorry. 2.8 does not have that pin.
But that pin is not relevant here.

Misterious are that I click to gmoccapy.toolchange-change pin in halshow. I see toolchange-change and toolchange-changed pin.

Only a little uncertainty in halshow. It just does "halcmd show pin gmoccapy.toolchange-change" which lists you both pins.

Yes I checked postgui-halfile list many times. Also check halshow and pins is not connected.
Then edit /usr/bin/gmoccapy line 4422.
There is definition def on_tool_change i simple rewrite it that only set self.halcomp["toolchange-changed"] = true
No show some dialog window atc... simple set variable to true.
Restart Lcnc and nothing happend. Dialog is still there. So I have no idea which code call it.

You can try the gmoccapy sim sample configuration.
This config should not show any tool change dialog because the corresponding lines are commented out: github.com/LinuxCNC/linuxcnc/blob/2.8/co...gmoccapy_postgui.hal

Hi there
When I want to disable tool changes, I disable the M6 in the post

You can also remove that line in your gcode in the post editor

@Jeff_in_Wa: This is to disable the tool change window, not the tool change itself!

I would try to connect gmoccapy.tool-change with gmoccapy.tool-changed without connected them ti iocontrol.

Norbert

Sorry it was my fault. Today I found that I havent connected iocontrol.0.tool-changed pin.
Thanks so much all.