MPG simulation Gmoccapy

Hello everyone I want to use Gmoccapy for a simulation stand, but I ran into such a problem that I can't process MPG signals to move along the axes. Do you have any ideas how I can implement this?
I tried to set a coefficient in encoder.positon and output it to axis.N.jog-scale, but it didn't end with luck. I'm thinking of using sim axis hardware, for conversion and movement. Can I do it?
 

I think you would want to use encoder counts rather than position

Have a look here:

www.forum.linuxcnc.org/gmoccapy/41189-mp...gmoccapy-help#195906

You want to use a hardware encoder / MPG that should control you simulation? Or how exactly does your setup look like?