Tool table with wear

More
2 years 10 months ago #288012 by dinkata
Tool table with wear was created by dinkata
Hello,
my lathe configuratin Mesa 5i25 + 7i77 . Linuxcnc 2.9.1 with Gmoccapy.
Is there a table of tools with wear !
Thanks !

Please Log in to join the conversation.

More
2 years 10 months ago #288062 by HansU
Replied by HansU on topic Tool table with wear
As far as I know this is not supported in gmoccapy.

Please Log in to join the conversation.

More
2 years 10 months ago #288100 by cmorley
Replied by cmorley on topic Tool table with wear
The display of tool offsets in the offsets page for lathes should work (tools numbers above 10000 are assumed wear settings.)
But i haven't tried it recently.
But linuxcnc needs to use remap code to use the wear offsets.

Please Log in to join the conversation.

More
2 years 10 months ago #288101 by cmorley
Replied by cmorley on topic Tool table with wear
add:
LATHE_WEAR_OFFSETS = 1

to the INI file, under [DISPLAY]

Please Log in to join the conversation.

More
2 years 10 months ago #288212 by virencq
Replied by virencq on topic Tool table with wear
Hi, Place in .ini file under [DISPLAY] section:
LATHE = 1
BACK_TOOL_LATHE = 0
LATHE_WEAR_OFFSETS = 1

rename attached file to tool.tbl

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.089 seconds
Powered by Kunena Forum