The situation is this - after updating to 2.9, I can't make the probe screen by vers work completely.
I converted one version myself from the verified version to 2.8, the second (newer) version here on the forum. As a result, the same appears in both!!! error - Outside measure X- stops after the macro has been run, does not return the axis to the start position, and does not reset the coordinate.
Attachment not found
Attachment not found
If you use a complex measurement (for example, the center of a hole or the center of two walls), everything works fine. For more than a week I have not been able to find a solution, like the macro code is identical, the python code for X + and X is also identical.
Attachment not found
Who understands the code well - I ask you to help!!!
If moderators think this topic is for another section - please move to the correct one.
In the attachment sim configuration in which you can see the problem
Code:
# X+
def on_xp_released(self, gtkbutton, data = None):
self.command.mode( linuxcnc.MODE_MDI )
self.command.wait_complete()
# move X - xy_clearance
s="""G91
G1 X-%f
G90""" % (self.spbtn1_xy_clearance.get_value())
if self.gcode(s) == -1:
return
if self.z_clearance_down() == -1:
return
# Start xplus.ngc
if self.ocode ("O<xplus> call") == -1:
return
a=self.probed_position_with_offsets()
xres=float(a[0])+0.5*self.spbtn1_probe_diam.get_value()
self.lb_probe_xp.set_text( "%.4f" % xres )
self.lenght_x()
self.add_history(gtkbutton.get_tooltip_text(),"XpLx",0,0,xres,self.lenght_x(),0,0,0,0,0,0,0)
# move Z to start point up
if self.z_clearance_up() == -1:
return
# move to finded point
s = """G1 X%f
M65P0""" % xres
if self.gcode(s) == -1:
return
self.set_zerro("X")
# X-
def on_xm_released(self, gtkbutton, data = None):
self.command.mode( linuxcnc.MODE_MDI )
self.command.wait_complete()
# move X + xy_clearance
s="""G91
G1 X%f
G90""" % (self.spbtn1_xy_clearance.get_value())
if self.gcode(s) == -1:
return
if self.z_clearance_down() == -1:
return
# Start xminus.ngc
if self.ocode ("O<xminus> call") == -1:
return
a=self.probed_position_with_offsets()
xres=float(a[0]-0.5*self.spbtn1_probe_diam.get_value())
self.lb_probe_xm.set_text( "%.4f" % xres )
self.lenght_x()
self.add_history(gtkbutton.get_tooltip_text(),"XmLx",xres,0,0,self.lenght_x(),0,0,0,0,0,0,0)
# move Z to start point up
if self.z_clearance_up() == -1:
return
# move to finded point
s = """G1 X%f
M65P0""" % (xres)
if self.gcode(s) == -1:
return
self.set_zerro("X")
