Auto tool measurment files

report file missing

I edit and add it as a text at the previous comment. Sorry for not being conventional. I have aldo the problem that the cnc is downstairs and the computer with internet is upstairs.

The problem is in the file  called in line 10 of the file  'postgui_call_list.hal':

postgui_call_list.hal:10: Pin 'iocontrol.0.tool-prepare' was already linked to signal 'tool-prepare-loopback'

As a first step you can remove or comment (#) the hal line in question and try to start your config again.

Here is the postgui_call_list.hal

the line 10 doesnt have a #
I did remove the others # but didnt work
I did eliminate the first five lines didnt work either

I am sorry let me comment it as well

Yes when I commented it works. I can see the probe configurations on gmoccapy as well. I am looking for new problems now thanks a lot.

The problem now is that doesnt let me change the tool. Just doesnt change the tools there is no errors.
It has to do with the commentation we did?
Do you believe that I have to make a fresh post with all the informations together?

is this the only line you commented?

Yes I did comment only this line.
I think I found the solution. I uncomment again the line 10 of the postgui file and I did comment the one relative to iocontrol.0.tool-prepare on the hal file and seems it works. I did my first intent to change tool. I think now i have to understand the dimensions. Thanks again. Hope I am near to the end.

Here is another problem. 
I did connect my probe as a normally closed switch. I think this is correct for safety reasons.
But when I run the tool change it informs me that the probe is already trigged.
So I did try to ad -in, -in.not, -not to invert the switch after 05 at the HAL file# --- PROBE-IN ---
net probe-in <= hm2_7i96s.0.inm.00.input-05

But didnt work
any sugestions?