Tool Setter Gmoccapy

More
2 years 8 months ago #294071 by RIDO_JIMO
Tool Setter Gmoccapy was created by RIDO_JIMO
Hello, 

I am currently testing a Gmoccapy setup on a simple 3-axis machine. The machine will operate in a simple way with manual tool changes only. I have already installed a toolsetter at this point. Has anyone successfully made Gmoccapy work with a toolsetter using a subroutine just to get the tool offsets ?

Thanks

Please Log in to join the conversation.

More
2 years 8 months ago #294073 by Aciera
Replied by Aciera on topic Tool Setter Gmoccapy
Have you found this?:
linuxcnc.org/docs/html/gui/gmoccapy.html...uto-tool-measurement

Please Log in to join the conversation.

More
2 years 8 months ago #294083 by RIDO_JIMO
Replied by RIDO_JIMO on topic Tool Setter Gmoccapy
oh, thanks!!!
That will help a lot!!!

Please Log in to join the conversation.

More
2 years 8 months ago #294084 by RIDO_JIMO
Replied by RIDO_JIMO on topic Tool Setter Gmoccapy
It is the same way in QtDragon?

Please Log in to join the conversation.

More
2 years 8 months ago #294502 by RIDO_JIMO
Replied by RIDO_JIMO on topic Tool Setter Gmoccapy
Hello,

Can someone help me configure my Tool Setter in QTdragon?
i will change tools manually.

Do i need macros or its just INI config?

Please Log in to join the conversation.

More
2 years 8 months ago #294506 by Aciera
Replied by Aciera on topic Tool Setter Gmoccapy
You may want to open a new thread in the qtvcp section.
forum.linuxcnc.org/qtvcp

Please Log in to join the conversation.

Time to create page: 0.148 seconds
Powered by Kunena Forum