Error when trying to open Gmoccapy confiuration.

So I've decided to start with a new config and work from there, no embedded tabs to worry about.

New version of Linux, new version of Linuxcnc, new configuration, that's bound to open!!!..........not a bit of it. Another error box.

All as attached.

Any offers?

   
 

Buffer overflow and segmentation faults all over.
Do you still have the RT-Preempt kernel installed? If yes, start with it and try running your config, might be something with RTAI kernel as i have seen those errors before with it.

I'll have a look, I can't remember. I did start with RT-Prempt but latency was poor.

Does it follow that since any of the Gmoccapy sims open, that the problem does not lie with the kernel?

The problem, to the uninitiated, is what stepconf wizard produces.