I have been running gmoccapy with a joypad with RIP tag v2.9.2 for quite a while on my mill, router, and lathe.
When I check out and build branch 2.9 or tag v2.9.3 and RIP with the exact same mill.ini, I am now getting jog Y negative direction (slow/fast) actions whenever I press the btn-joystick and btn-thumb on my joypad. I have these two joypad buttons set up to select speed (
wiki.linuxcnc.org/cgi-bin/wiki.pl?Simple_Remote_Pendant
).
I used hal watch to look at gmoccapy.jog.axis.joy-y-minus and it stays false when I press the buttons. If I do use the joy-y-minus set control it jogs at the same speeds(depending on turtle/rabbit) as when I press the joypad btn so the joypad buttons seems to be triggering the jog but I don't know how this gets mapped as there is nothing in my config that did that?
Looking at my gmoccapy.preferences
use_keyboard_shortcuts = False
I had to install version 4 of gtk something to get v2.9.3 to run, now I can't run run 2.9.2 anymore.
Any help/hints would be appreciated.
