Leaving from TOOL page

If I press any of these buttons, their commands are executed, but Gmoccapy switches to MANUAL_PAGE instead of staying on the TOOL_PAGE.
 

MANUAL_PAGE:
 

I think I could fix it. But I don't know if that was intentional.

My English is bad. Could you explain your message easier?

I believe this is the intended behavior.

I would be interested in Norbert's opinion.

Yes, that is a wanted behavior!
All the mentioned buttons leads to a tool change, so after that for sure you want to go on with your work, so why do you want to stay in tool table page?

Norbert

Thanks for the answer.
I will respect that. It's just a matter of opinion.
I mostly work as an LCNC integrator, or teach someone. So I often need to switch between several tools and always have to go back.

Sometimes after using those three buttons I get stuck on the TOOL_PAGE page. Now I know that this is a bug. That's also why I opened this thread.