GMOCCAPY 3.4.9 LCD7" can not display the whole GUI

More
1 year 5 months ago #328837 by foxlabs
GMOCCAPY 3.4.9 LCD7" can not display the whole GUI was created by foxlabs
Hello Guys,
I use a 7"LCD resolution 1024x600 for display the GUI can not display all ,especilly the height ,does anyone met this problem ,how to solve this problem?Thank you !

Please Log in to join the conversation.

More
1 year 5 months ago #328852 by Aciera
Replied by Aciera on topic GMOCCAPY 3.4.9 LCD7" can not display the whole GUI
If I am not mistaken then 600 vertical is not enough for the regular version, maybe this custom config for 800x600 helps:
github.com/LinuxCNC/linuxcnc/pull/2837

Please Log in to join the conversation.

More
1 year 5 months ago #328954 by foxlabs
Replied by foxlabs on topic GMOCCAPY 3.4.9 LCD7" can not display the whole GUI
Hello Aciera, Thank you for your replay , The orignal GMOCCAPY  I used on RPI4 is OK, but on RPI5 is not OK

Please Log in to join the conversation.

More
1 year 3 months ago #331145 by HansU
Replied by HansU on topic GMOCCAPY 3.4.9 LCD7" can not display the whole GUI
Can you post some screenshots to show the difference?

Please Log in to join the conversation.

Time to create page: 0.088 seconds
Powered by Kunena Forum