Gmoccapy tool setter install "errors"

Hi need some advice I tried to do this much as possible on my own but ran into a error not sure whats the best way to get around it.Looks like i have two pins for tool change ? 

The problem is that you can not reuse a hal pin anywhere in that hal file or another hal file. However you can connect multiple hal input pins to a hal signal name (but only one hal output pin).

Not seeing what you have going on in your other hal files I think this might get you going change this line in your post gui hal file from:
net tool-change gmoccapy.toolchange-change <= iocontrol.0.tool-change
to:
net tool-change-request iocontrol.0.tool-change

That may still not get your config working, if you have other similar mistakes in your postgui hal file. But it will get you on to the next one.

Made the change net tool-change-request iocontrol.0.tool-change.
 

[Gmoccapy.GMOCCAPY.GETINIINFO][[33mWARNING[0m] No DEFAULT_SPINDLE_SPEED entry found in [DISPLAY] of INI file (getiniinfo.py:282)
[Gmoccapy][[33mWARNING[0m] No virtual keyboard installed, we checked for <onboard>. Try 'sudo apt-get install onboard'. (gmoccapy:2112)
gmoccapy_postgui.hal:24: Pin 'gmoccapy.toolchange-change' was already linked to signal 'tool-change-request'
10530

This is after making a few changes trying to figure it out?
any help would be helpful





(gmoccapy:3126): Gtk-CRITICAL **: 15:22:03.887: gtk_entry_set_text: assertion 'text != NULL' failed
[Gmoccapy.GMOCCAPY.GETINIINFO][[33mWARNING[0m] Found kinstype=BOTH but using trivkins. It is not recommended to do so! Will use mode to switch between Joints and World mode, hopefully supported by the used <<trivkins>> module. (getiniinfo.py:182)
15:22:05.211 WARNING Config: mousetweaks GSettings schema not found, mousetweaks integration disabled.
gmoccapy_postgui.hal:24: Pin 'gmoccapy.toolchange-change' was already linked to signal 'tool-change-request'
/usr/lib/python3/dist-packages/gi/overrides/GObject.py:493: Warning: ../../../gobject/gsignal.c:2772: instance '0x15975de0' has no handler with id '33554454'
return func(*args, **kwargs)
3075

This is from your 'gmoccapy_postgui.hal':
As has already been stated, you cannot reuse the same halpins use the signals they were assigned to.
Maybe this helps to explain some of the basics:
linuxcnc.org/docs/html/hal/intro.html

Ok I got it , Guess I didn't pay attention just copied and paste Gmoccapy config to get it working not reading if I needed everything.

Not Getting errors on start up, but a pop up saying file ended with no percent sign (%) or program end (M2)      

Forgot to say I got the error after asking for tool change in the GUI.

I was able to figure out the end of line issue , but now not getting any movement after asking for tool change or pop up window?