Gmoccapy Raspberry Pi 4/5 OS based on Debian Trixie Tool Table Error?

I don't know if it belongs to here, but after fresh install Raspberry Pi 4/5 OS based on Debian Trixie, and initial setup I'm not able change tool offsets at all. Also work offset changes are displayed only after clicking off and back on "work offsets" page.

Is it this bug?
github.com/LinuxCNC/linuxcnc/pull/3474

Zdavim!
Doesn't seem so(I don't know). Switched from Raspberry PI to PC and Debian 12 Bookworm and I can edit tool offsets no problem.

Edit: Just tried previous version rpi-5-debian-bookworm-6.12.11-arm64-ext4-2025-01-27-0140.img.xz, and editing tools works!

It shouldn't be the OS it should be the version of Liunxcnc installed.

What happens if you upgrade the version of Linuxcnc on the current install. I only use axis.