can not jog axis in Gmoccapy

Here are the Hal and ini files.
Thanks

1. ini file is missing

2. Take the config that uses AXIS gui (which apparently works), open the ini file and in the [DISPLAY] section change 'DISPLAY = axis' to 'DISPLAY = gmoccapy'. The config should now start with gmoccapy and jogging should work using the on screen jogging buttons.


3. Looking at the header in your hal file it seems that you are using a rather old prerelease of version 2.9 '# Using LinuxCNC version: Master (2.9)'
Unless there is a particular reason for this I would recommend using a more recent release (eg 2.9.10):
github.com/LinuxCNC/linuxcnc/releases#release-v2.9.10

I tried your suggestion of changing the "Display = gmoccapy", with no success.
Then I decided to update to v2.9.10 .
That did the trick, I changed "Display = gmoccapy" in axis. Now i can jog and home all axis in gmoccapy.
Thank you for your patience..