All my "Mach3 Cloned Wizards" for lathe (NGCGUI routines)

ContinenteCNC
Topic Author
Offline
Premium Member

2 years 2 months ago #306681 by ContinenteCNC

All my "Mach3 Cloned Wizards" for lathe (NGCGUI routines) was created by ContinenteCNC

Hi!

These are probably all my lathe NGCGUI routines. I have been making them for several years now. Everytime I need a new one I find some time to code it down.

I tried to keep them as close as Mach3 Wizards as I could. I even edited the images to look similar.

They were running just fine in my latest retrofit.

I hope it helps someone.

Attachment not found

Please Log in to join the conversation.

tommylight
Away
Administrator

2 years 2 months ago #306687 by tommylight

Replied by tommylight on topic All my "Mach3 Cloned Wizards" for lathe (NGCGUI routines)

Very nice, thank you.

Please Log in to join the conversation.

BoxCNC
Offline
New Member

1 year 11 months ago #314667 by BoxCNC

Replied by BoxCNC on topic All my "Mach3 Cloned Wizards" for lathe (NGCGUI routines)

Hi. this archive can't exstract.

Please Log in to join the conversation.

Aciera
Offline
Administrator

1 year 11 months ago #314668 by Aciera

Replied by Aciera on topic All my "Mach3 Cloned Wizards" for lathe (NGCGUI routines)

Hi. this archive can't exstract.

Works fine for me.

Please Log in to join the conversation.

tommylight
Away
Administrator

1 year 11 months ago #314669 by tommylight

Replied by tommylight on topic All my "Mach3 Cloned Wizards" for lathe (NGCGUI routines)

BoxCNC wrote:
Hi. this archive can't exstract.

If using Debian:
sudo apt install unrar

Please Log in to join the conversation.

Time to create page: 0.084 seconds