Nativecam 0.1.14 rotation problem

More
8 years 11 months ago #102426 by chrisfairbrother
Nativecam 0.1.14 rotation problem was created by chrisfairbrother
Hi Fern, I have updated to version 0.1.14 this morning. I am having trouble with the rotation of a slot/oval from one point.
At 0 degrees, all is ok, but at an angle the rotation is incorrect. See the attached pictures.
Keep up the good work.

Please Log in to join the conversation.

More
8 years 11 months ago #102427 by FernV
Replied by FernV on topic Nativecam 0.1.14 rotation problem
Hi,

For a reason I do not know yet, the angle is multiplied by 25.4 on all metric setup.

For a quick fix this morning, enter 90/25.4 for the rotation

Fern
P.S. Slot with 2 points is OK

Please Log in to join the conversation.

More
8 years 11 months ago #102428 by chrisfairbrother
Replied by chrisfairbrother on topic Nativecam 0.1.14 rotation problem
Yes that corrects the problem. Serves me right for working in mm.
Many thanks

Please Log in to join the conversation.

More
8 years 11 months ago #102429 by FernV
Replied by FernV on topic Nativecam 0.1.14 rotation problem
Problem solved, enter rotation angle without dividing with 0.1.14a update

Fern

Please Log in to join the conversation.

More
8 years 11 months ago #102433 by chrisfairbrother
Replied by chrisfairbrother on topic Nativecam 0.1.14 rotation problem
tested 0.1.14a, all ok. many thanks for your quick response

Please Log in to join the conversation.

Time to create page: 0.082 seconds
Powered by Kunena Forum