Nativecam in Sim.axis not working

Hello Everyone.

I have Nativecam working on my machine and I love it. My issue is that I'm trying to get Nativecam working in my office in Virtualbox Ubuntu 18 installation for simulation only. I have been able to get a Nativecam tab in axis but it is blank. I believe my problem is most likely a file location problem. I have attached the linuxcnc terminal start results and the location of ncam in my file system. As always any help is immensely appreciated.

Thanks

Bill

hi
did you set the
FEATURES bitmask in versions of LinuxCNC

<2.8 Fearture = 30
>=2.8 it is a stand alone Oword bitmask that Ncam uses to get the subroutines

Thank you for the reply. I do not know where to set the FEATURES bitmask . Could you elaborate on how to find this.