Rigid Tapping on Tormach?

More
9 years 6 months ago #92109 by turbo
Rigid Tapping on Tormach? was created by turbo
I just bought a pcnc 770 a few weeks ago and of course now broke. I'm wondering if anyone here has added an encoder and gotten the 770 or 1100 to rigid tap. I'm not really new to LinuxCNC anymore, but I haven't messed with Pathpilot at all other than using it the way it came.

Please Log in to join the conversation.

More
9 years 6 months ago #92154 by andypugh
Replied by andypugh on topic Rigid Tapping on Tormach?
Does the system recognise a G33.1 instruction?

Please Log in to join the conversation.

More
9 years 6 months ago #92174 by turbo
Replied by turbo on topic Rigid Tapping on Tormach?
It's not in the manual.

Please Log in to join the conversation.

More
9 years 6 months ago #92175 by skunkworks
Replied by skunkworks on topic Rigid Tapping on Tormach?
www.cnczone.com/forums/tormach-pathpilot...are-forum-posts.html

Please Log in to join the conversation.

Time to create page: 0.073 seconds
Powered by Kunena Forum