Running Pathpilot without a Mesa board

Hello!
A friend is trying to run Pathpilot but he doesn’t have a Mesa card. The program won’t run. Anyone know if it’s possible to get Pathpilot up and running without the Mesa card? I think once he sees how convenient and easy PP is to use, he may convert over from Mach. :woohoo:
Thanks, Scot

Did you see this thread?

forum.linuxcnc.org/pathpilot/30222-setti...-port-tutoral-part-3

No, I did not see that thread. Thank you, I will forward the link to him and see if it helps.