Using PNCconf with PathPilot

Has anyone tried using PNCconf with PathPilot to help setup a new Config ??

( TP

path pilot got nice presetups
so it may be only a view changes to a standard
go to the homepage
or get it from the tread here called pathpilot config

Are you looking to run PNCConf from PP or run it from a LinuxCNC build and copy the INI and HAL files to PP?

I've run pcnconf from pp install after coping all needed files to the ~/tmc directory.
after you create it you just need to map some of the pins over to the tormach pins so PP can work .

running halshow you can see all the tormach specific stuff ( not actually allow of it) then connect the pins over.

Can you explain how to set up PNCconfig in PathPilot ?? I am setting up a 7i80 in PathPilot and it seems that PNCconf would be very handy to use.