Test encoder signals

Vmax549
Topic Author
Offline
Platinum Member

7 years 3 months ago #140494 by Vmax549

Test encoder signals was created by Vmax549

What is the best method to test the spindle encoder signals in PathPilot ??

( ;-)

Please Log in to join the conversation.

pl7i92
Offline
Platinum Member

7 years 3 months ago #140529 by pl7i92

Replied by pl7i92 on topic Test encoder signals

you can use halshow and set a counter to the signal so you see in watch tab if it is triggering the pulses

Please Log in to join the conversation.

tommylight
Away
Administrator

7 years 3 months ago #140548 by tommylight

Replied by tommylight on topic Test encoder signals

pl7i92 wrote: you can use halshow and set a counter to the signal so you see in watch tab if it is triggering the pulses

How ?
He is using pathpilot, i never used it although i do have version 1.9 somewhere, it complained a lot when i did try to install it, so i abandoned it, for now.

Please Log in to join the conversation.

smgvbest
Offline
Elite Member

7 years 3 months ago #140552 by smgvbest

Replied by smgvbest on topic Test encoder signals

see my post here on enabling halshow in PPV2
forum.linuxcnc.org/pathpilot/35257-halsh...h-pathpilot-2#121725

if I can find I I'll post a patch to PP code to add a ADMIN HALSHOW command

Please Log in to join the conversation.

Time to create page: 0.074 seconds