Upgrade to PP 2.24

More
7 years 1 month ago #146006 by Robi63
Upgrade to PP 2.24 was created by Robi63
Hello,

I upgraded my lathe to Pathpilot 2.24, when I start the spindle does not start.
Gives me this error: " RPM must be between 0 and 0 in present spindle config" .
Where is the spindle speed configured?
On Pathpilot 2.16 I didn't have this problem.

Thanks for every suggestion

Please Log in to join the conversation.

More
7 years 1 month ago #146384 by NewToRouting
Replied by NewToRouting on topic Upgrade to PP 2.24
Sorry I can't answer that. But would you mind pointing me to where I could get a copy. I'm not sure what I should buy on their web site?

Thanks

Please Log in to join the conversation.

More
7 years 1 week ago #148319 by smgvbest
Replied by smgvbest on topic Upgrade to PP 2.24
can you post of screen capture of the screen while its displaying the error?

Please Log in to join the conversation.

More
7 years 1 week ago #148320 by smgvbest
Replied by smgvbest on topic Upgrade to PP 2.24
go here and purchase
www.tormach.com/store/index.php?app=ecom&ns=prodshow&ref=38249

Please Log in to join the conversation.

More
7 years 1 week ago #148333 by Robi63
Replied by Robi63 on topic Upgrade to PP 2.24
I solved
It was due to [SPINDLE_9] in the .ini file and hal
I solved by correcting in [SPINDLE]

Thanks

Please Log in to join the conversation.

More
7 years 1 week ago #148342 by NewToRouting
Replied by NewToRouting on topic Upgrade to PP 2.24
Thanks for the reply I really appreciate it. Does this upgrade look for a previous version of PP to proceed or can I do a clean install for the USB?



Thanks Again - ed

Please Log in to join the conversation.

More
7 years 1 week ago #148344 by smgvbest
Replied by smgvbest on topic Upgrade to PP 2.24
I used it for a clean install.
Just be sure your bios is set to uefi boot from the usb stick

Please Log in to join the conversation.

More
7 years 1 week ago #148490 by NewToRouting
Replied by NewToRouting on topic Upgrade to PP 2.24
Thanks again .I really do appreciate your help.

Please Log in to join the conversation.

More
6 years 11 months ago #149980 by belli
Replied by belli on topic Upgrade to PP 2.24
Hey NTR,

I just did a fresh install of PP v2 and it has a selection for every 1100 down to serial number 1. I think you can just install PPv2 without any troubles. I didn't install any of the older versions coz my BOB is new.

Please Log in to join the conversation.

More
6 years 11 months ago #150259 by NewToRouting
Replied by NewToRouting on topic Upgrade to PP 2.24
Thanks for your reply.

Please Log in to join the conversation.

Time to create page: 0.216 seconds
Powered by Kunena Forum