M66 doesn't work

My setup is a little bit weird cause im in third wolrd country so i have to stick with third world solution

This is pci e motion control card


This is linuxcnc bob


I use mach 3 board + relay board for io pin


Here's the loadrt line, but it no hm2 ::pinch:


I dont know how to open halmeter, i will figure out how to do it later but this is io port list show in operator_login

That seems to be a clone of a 5i25. So there is no real guarantee that the dmesg output that tells you that GPIO 32 is on DB25 pin 12 is correct.

Can you use Halshow with PathPilot? That would let you check which physical input (if any) triggers when you toggle the physical input.

andypugh wrote: That seems to be a clone of a 5i25.

From Vietnam, of all places, and this is the second time i am seeing them on the web.
Back on subject, he did mention he is using USB something for inputs, so in that case i am not sure it will work.

You're right, this board is in vietnam.
About usbio inputs i mention in the subject, i mean when i check the port by hand it's work

This is my halmeter
Signals






Pins 32

My halscope seems like everything work's fine

<iframe width="560" height="315" src="" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>

I think almost found it, thanks for the halmeter, its very helpful
M66 code in my ini file wasn't turn on


I dont understand M64 wasn't turn on too but it's still function, my m66 still doesn't work and here's the error in status tab

Problem is solved
I update pathpilot from virgin version to ver 2.0.1 and M66 is fixed
I found out it in tormach updates release notes ver 2.0.1
The file is not recognized is invoved with M66, i just spend 3 days for nothing

Thanks for reporting back with the solution.

Duongtantai8624 wrote: Problem is solved
I update pathpilot from virgin version to ver 2.0.1 and M66 is fixed
I found out it in tormach updates release notes ver 2.0.1
The file is not recognized is invoved with M66, i just spend 3 days for nothing

Attachment not found

Might as well go to the latest. They have fixed lots of errors since then.