Path Pilot and enabling the 4th axis

Hello Linux ForumI am running Path Pilot on a Tormach 1100 Series3.  Attached is the post processor that I am currently using. I have generated .nc code for using my 4th axis as a lathe to create a simple spool.
The CAM software is Cambam
My question is how to enable the 4th axis of my machine?

Any advice greatly appreicated. Thank you!

Never used Path Pilot, but the attachments are missing.

Thanks for responding.  I will get back to you shortly
 

The manual for the 1100-3 describes enabling and use of the 4th axis. Is your question really more like: how do I get the post processor for CamBam to generate 4th axis code?

I would that would be better asked on the CamBam forum, they are quite knowledgeable and helpful.