Path pilot with 7i92tm and 7i77

About to start retrofiting another mill with analog dc servos to linux cnc and id like to use path pilot. I'm thinking id like to use  7I92TM Anything I/O Ethernet card 1x DB25 Male, 1x 26 pin header  and a  7I77 Analog servo interface plus I/O daughtercard - Sourcing output version. Are these cards compatible with path pilot? Or there a better card combo i should be looking at to achieve this?

Thank You
Austin

Is there a way to check if any of the existing Tormach machines use that combo?

Pretty sure a 7I92T[X] will be detected as a 7I92 which PathPilot supports
You will need to disable PathPilots re-flashing script and the hal/ini files
will have to be created by LinuxCNC tools with any PathPilot specific bits
copy-pasted froma stock PathPilot configuration file set,

Wasn't sure if the 7i92tm showed up the same or not. But if needed i have a old 7i92 on another machine i can swap. Are yall thinking that the daughter card doesn't matter to pathpilot?

The 7I92T should show up as a 7I92 to Path Pilot (It does to LinuxCNC)