Changing the default Jog Increment

Has anyone ran across the section of code where PathPilot sets the Default Jog increment to .0001 ?? I would really like to change that.

( TP

LinuxCNC has those in the ini file, no idea if they are in Path Pilot there or not.
Should be, though.

Vmax549 wrote:

Has anyone ran across the section of code where PathPilot sets the Default Jog increment to .0001 ?? I would really like to change that.

( TP

If you are using a mill, it sets it in: /python/tormach_mill_ui.py
If you are using plasma, it sets it in: /python/tormach_plasma_ui.py
If you are using lathe, it sets it in: /python/tormach_lathe_ui.py

The line is common to all of them:

It doesnt matter if you use imperial or metric, left to right the four jog increments are 0, 1, 2, 3.

Change the value to whatever you want to be selected when you start PathPilot.

As always, backup before changes, and this will be wiped out with upgrades, etc.

Thanks SNOW, I had search the UI file but used the wrong search words.

That did the trick

( TP