Plasma-Specific Docs

bevins wrote: Rodw, thats fantastic. Nice writeup.

Is there going to be a section on hal pins and how this plasmac beast works? Configs and such?

Bob, thanks. I didn't really think this should be a manual for plasmac. I thought that might be a separate project. :woohoo:
But when I think about it, perhaps there should be a section outlining plasma specific I/O pins and perhaps a section explaining how to connect a THCAD card.

Ill Volunteer to redraw the Ohmic sensing schematic if everyone is happy with that.

I've just updated the document based on Bevin's suggestions in the earlier thread. 17 pages phew!

thefabricator03 wrote: Ill Volunteer to redraw the Ohmic sensing schematic if everyone is happy with that.

Awesome, Stefan, you have my email address.

Just a heads up, I've replaced the earlier document with a final version that is what will end up in the LinuxCNC V 2.9 documents. I paid my graphics guy to redo some images so all content is now open source.

Phill is just checking in with the devs before this is pushed to its rightful home.

So thanks to all of those who have had input to this, Phill, Tommy, Islander261, Grotius, fabricator03 and many others who have contributed to my understanding of plasma since trying to get my spaceship plasma to take off!