New Plasma build question

And to think you had to travel all around the world to get that help you mentioned!

P.S. Gaby said to say hi.

Thanks, I really enjoyed my afternoon with you both.
.

Including some obscure countries like mine !

Yes, I have been looking for an easier way to get there to make sure you are still off the coffee (or was it coke? bottled of course.
.

I hate to think how many GnT's and bottles on wine I had to drink to get around the wonderful places I (we) visited.

Also, I would like to thank you all for the great hospitality I (we) were given.

Clive S wrote: .

Including some obscure countries like mine !

Yes, I have been looking for an easier way to get there to make sure you are still off the coffee (or was it coke? bottled of course.
.

Esspreso, for some unknown reason i have developed an aversion to it, very strange as it was the only thing i really enjoyed drinking besides water. Other cr@ppy coffee's i can still drink. And i drink coke for the suggar in it as i very rarely eat sweets.
I blame the last dehidration i went through some 5 months ago, again strange since there are 4 rivers in a 20KM radius !
I am leaving that mistery to be solved by later generations !

Still haven't had the guts to switch on the replacement 7i76e since mine burnt.
I continue cabling and documenting which is fun too.

Next step the installation of the thcad 300

Please check following and correct if wrong.


Don't know what the Red screw terminal connector in the middle is..
Left torch - , unknown, torch relais input, clamp+


Guess I take it directly from here...





Thank you!


Just tested my new 7i76e... 10.10.10.10 working OK,.! Great!

If it helps I put a 1M resistor in each leg. But I used a THC-10

photos.app.goo.gl/PdDUHF2uHGWHWLPw7

Clive S wrote: If it helps I put a 1M resistor in each leg. But I used a THC-10

photos.app.goo.gl/PdDUHF2uHGWHWLPw7

Not necessary on the thcad-300

CNCFred wrote: Please check following and correct if wrong.

Attachment not found

Admiring the CAD skills. That THCAD looks so lifelike

thefabricator03 wrote:
Admiring the CAD skills. That THCAD looks so lifelike

LOL

Thank you for recognizing the effort I put into my drawings.

So no correction means go ahead.

And my 7i76e still runs......

CNCFred wrote: So no correction means go ahead.

Yes, I'm sure you read the plasma primer! its all in there (without the amazing CAD work)!

Read it some time ago, but couldn't remember it was in there!
Pitty I chose thcad 300 since I thought it is the only way to connect to high V. Didn't know about the 1Mohm solution for thcad 10.
If I get finally a Hypertherm got to change that too.