Updated to Master Branch, Stuck in E-Stop

No, I did not figure it out. Perhaps it was just time for a fresh install anyway.

Table is back up and running and working great!

photos.app.goo.gl/14kc5BWsZBLryM3N6

Uthayne wrote: No, I did not figure it out. Perhaps it was just time for a fresh install anyway.

Table is back up and running and working great!

photos.app.goo.gl/14kc5BWsZBLryM3N6

Glad to hear it, that looks cool...

rodw wrote: Is this a gantry machine? If so, its set up as wrong for 2.8/2.9

Code:

net emcmot.02.enable <= joint.2.amp-enable-out net emcmot.02.enable => hm2_5i25.0.stepgen.03.enable hm2_5i25.0.stepgen.04.enable

Why does joint 2 connect to stepgens 3 & 4?

It doesn't really matter, all the amp-enable pins toggle at the same time, there is actually no point having one per axis.