Trying to learn as i go, i am working on configuring plasmac and need to put in the HAL pin's for what i am using in this setup.
I see the examples like: parport.0.pin-10-in-not
hm2_7i96.0.gpio.008.in
Obviously depending on the hardware that would change to suit, I am running 6i25 and 7i76 cards
i am sort of guessing that my settings would be close to:
FLOAT SWITCH: hm2_5i25.0.7i76.0.0.input-03-in (its a normally open switch)
ARC OK: hm2_5i25.0.7i76.0.0.input-10
TORCH ON:
ARC VOLTAGE: encoder.0.velocity
Just after advice on how to figure out what i would put in the (TORCH ON) field, also if the others would be correct? Thanks
Attachment not found
Attachment not found
