(Solved) QTPlasmac scaling issue

More
5 years 6 months ago #205778 by bevins
(Solved) QTPlasmac scaling issue was created by bevins
I am havng an issue I am up to the latest QTplasmac and I went to open a file and it was scaled somehow. I loaded same file in plasmac config and it was fine.

Is there a scale factor somewhere I missed?

see the pics between QTplasmac and plasmac loading the same file.

Attachment not found




Attachment not found

Please Log in to join the conversation.

More
5 years 6 months ago #205780 by bevins
Replied by bevins on topic (Solved) QTPlasmac scaling issue
I put the OFFSET_AV_RATIO to 0,

Still has the same behaviour. I think the X is scaled.

Please Log in to join the conversation.

More
5 years 6 months ago #205783 by snowgoer540
Replied by snowgoer540 on topic (Solved) QTPlasmac scaling issue
Can you post the backup from plasmac as well?

Please Log in to join the conversation.

More
5 years 6 months ago #205784 by bevins
Replied by bevins on topic (Solved) QTPlasmac scaling issue

snowgoer540 wrote: Can you post the backup from plasmac as well?


I did, its in the first post.... oops, yeah my mistake. Ill post in a sec

Please Log in to join the conversation.

More
5 years 6 months ago #205785 by bevins
Replied by bevins on topic (Solved) QTPlasmac scaling issue

snowgoer540 wrote: Can you post the backup from plasmac as well?


Plasmac config attached

Please Log in to join the conversation.

More
5 years 6 months ago #205787 by bevins
Replied by bevins on topic (Solved) QTPlasmac scaling issue
Here is an image from conversational screen. Circle 5" diameter, you see in the preview it is scaled on the X.

Attachment not found

Please Log in to join the conversation.

More
5 years 6 months ago #205803 by bevins
Replied by bevins on topic (Solved) QTPlasmac scaling issue
snowgoer540: Were you able to replicate this?

Please Log in to join the conversation.

More
5 years 6 months ago #205835 by bevins
Replied by bevins on topic (Solved) QTPlasmac scaling issue
Am I the only one having this issue?

Please Log in to join the conversation.

More
5 years 6 months ago #205836 by snowgoer540
Replied by snowgoer540 on topic (Solved) QTPlasmac scaling issue
I've no way to simulate any of this at work. I just replied quick to save you time in case someone wanted to see your other config.

Not sure what your issue is.

It works fine here on v1.0.13:

Attachment not found

Please Log in to join the conversation.

More
5 years 6 months ago #205841 by phillc54
Replied by phillc54 on topic (Solved) QTPlasmac scaling issue
Try either commenting out this line in the .ini file
Code:
GEOMETRY = xxyz

or changing it to:
Code:
GEOMETRY = xyz

forum.linuxcnc.org/21-axis/38334-2-8-0-p...ction?start=0#156597

Please Log in to join the conversation.

Time to create page: 0.110 seconds
Powered by Kunena Forum