Torch isn’t firing

More
4 years 7 months ago #236775 by robertspark
Replied by robertspark on topic Torch isn’t firing
the manual is here, the last page, lower RHS shows the machine link.  unfortunately it does not show the torch connector pinout numbers for the link.

www.hypertherm.com/Download?fileId=HYP109171&zip=False
 

Please Log in to join the conversation.

More
4 years 7 months ago #236811 by Aldenflorio
Replied by Aldenflorio on topic Torch isn’t firing
Great. I’ll try that tomorrow when I’m with my table. I set it up for the Thcad-10 on plasmac. Did I do it right? I don’t understand that section very well

Please Log in to join the conversation.

More
4 years 7 months ago #236858 by Aldenflorio
Replied by Aldenflorio on topic Torch isn’t firing
Also, there’s a file I want to cut. But since the THC is acting up I can’t cut. Could I still cut if Linux can’t electronically detect an arc? If so how would i do that? I need this file cut out today and don’t have much time to figure out the THC deal. 

Please Log in to join the conversation.

More
4 years 7 months ago #236865 by tommylight
Replied by tommylight on topic Torch isn’t firing
If you are using QtPlasmaC, there is "ignore arc ok" button on the main screen.

Please Log in to join the conversation.

More
4 years 7 months ago #236876 by Aldenflorio
Replied by Aldenflorio on topic Torch isn’t firing
I don’t think I am. I know there’s an ignore THC button I think?

Please Log in to join the conversation.

More
4 years 7 months ago #236878 by snowgoer540
Replied by snowgoer540 on topic Torch isn’t firing
For PlasmaC, it's in the Run tab or Run panel, depending how you have it set up in the cutting mode section called "Ignore ArcOK".

For QtPlasmaC, it's in the Control frame of the Main tab and it's called "IGNORE OK"

Please Log in to join the conversation.

More
4 years 7 months ago #236886 by Aldenflorio
Replied by Aldenflorio on topic Torch isn’t firing
I placed the wire in the place you mentioned and it worked in the sense that it started the arc! My thc seems to be configured wrong still but this works for what I need at the moment. that being said, this is what it cuts when cutting a circle though 

Attachment not found



it cuts lines perfectly fine

Please Log in to join the conversation.

More
4 years 7 months ago #236887 by Aldenflorio
Replied by Aldenflorio on topic Torch isn’t firing

Attachment not found

Please Log in to join the conversation.

More
4 years 7 months ago #236888 by robertspark
Replied by robertspark on topic Torch isn’t firing
backlash or something loose?

problem seems to be on the same axis
note the powermax 45 (non xp) is 50:1 voltage divider, non adjustable.

Please Log in to join the conversation.

More
4 years 7 months ago #236890 by Aldenflorio
Replied by Aldenflorio on topic Torch isn’t firing
How do I configure for the backlash on an already configured machine?

also, yeah. Isn’t that what the fuse is for? I don’t understand the plasmac setup for the thcad with the hypertherm section

Please Log in to join the conversation.

Time to create page: 0.072 seconds
Powered by Kunena Forum