Laser Head Height Sensor – Looking for a Beta Tester

Uthayne wrote:

Are you still looking for testers? I am at a position where I have some capacity to perform testing on this device with you.

I have a 1000w fiber laser running LinuxCNC that I use ~15 hours a week for the last 2 years. I am actively pushing the limits of my height control using the BCL-amp - mainly limited by detection range and sampling rate. Looking at your specs I think it would blow the BCL amp out of the water and lead to more capabilities.

I have a Raytools head BM110
 

Nice to see someone running LinuxCNC with a fiber laser machine! I hope you get a chance to try the C2V Laser Sense and provide your feedback. 

Also, if you're willing to share, I'd be curious to know more about your machine setup/axes, whether you're using galvos, controller choice, and especially, your LinuxCNC configuration. Perhaps in a dedicated thread, as there aren't too many posts on here about laser machines.

Thank You !

Hello,

I tried to place a PayPal order on the website and was unable to complete checkout due to technical issues on your end.

Shipping Name is a required field.
Shipping Name is a required field.
Shipping Street is a required field.
Shipping city is a required field.
Shipping Status is a required field.
Shipping Zip Code is a required field.

These form fields were properly filled in.
Can you look into the website issue?

Hello,

The issue I was having with the checkout page was resolved by the webmaster.

Regards,
Brennen