Probe test problem

It shows the same behavior in both tabs. The weird thing is it worked the very first time I ran after the configurator did its thing.

Honestly I’m not sold on gmoccapy, was thinking of making another config to try axis.

phillc54 wrote:
You have a couple of issues with homing.
HOME_SEQUENCE is negative only for joints that need to home in sync.

Switched over to Axis today, and I remembered why I did a negative sign (-) before all joints, regardless of whether or not synchronized movement is necessary. - in front of a homing sequence also forces you to home that joint before you can move any of them. I dont want any movement to be possible prior to homing, so that's why I did that.

I started at 1 instead of 0 because I dont think you can have -0 (but I may be wrong about this, I dont know what the default keyboard values are for Joint 3 movement to try it out, since in joint mode left and right arrows = joint 0, up and down arrows = joint 1 and page up and page down = joint 2).

Just figured I'd follow up in case it helped someone, or there is flaw in my logic.

snowgoer540 wrote: I dont know what the default keyboard values are for Joint 3 movement to try it out, since in joint mode left and right arrows = joint 0, up and down arrows = joint 1 and page up and page down = joint 2).

joint 3 = [ and ]
in Axis go Help - Quick Reference, that shows all the keyboard shortcuts.

phillc54 wrote:

snowgoer540 wrote: I dont know what the default keyboard values are for Joint 3 movement to try it out, since in joint mode left and right arrows = joint 0, up and down arrows = joint 1 and page up and page down = joint 2).

joint 3 = [ and ]
in Axis go Help - Quick Reference, that shows all the keyboard shortcuts.

Thanks for the help!

I confirmed, negative sign on a 0 has no effect.