Trying to sort out the THC with PlasmaC

Clive S
Topic Author
Offline
Platinum Member

6 years 11 months ago #149315 by Clive S

Replied by Clive S on topic Trying to sort out the THC with PlasmaC

phillc54 wrote: Yes, there should be a JOG_INCREMENTS setting in the [DISPLAY] section of the .ini file.

Silly me. I had looked through the ini file and did not notice it was missing. The ini file was generated by the 7i96 configurator .

For info the configurator also puts in metric instead of mm although linuxcnc using Axis works OK but not with PlasmaC as this needs it to be mm.

Thanks again Phill for the continued help you give.

Please Log in to join the conversation.

phillc54
Offline
Platinum Member

6 years 11 months ago #149321 by phillc54

Replied by phillc54 on topic Trying to sort out the THC with PlasmaC

Thanks Clive,

Maybe you could let the author of that know, it also produces syntax that TWOPASS doesn't like:

Code:

loadrt hm2_eth board_ip="192.168.1.121" config="num_encoders=1num_stepgens=4"sserial_port_0=1

should be

Code:

loadrt hm2_eth board_ip="192.168.1.121" config="num_encoders=1 num_stepgens=4 sserial_port_0=1"

I wrote a workaround for this in the Configurator but it should be fixed at the source

Please Log in to join the conversation.

Time to create page: 0.030 seconds