Error after PlasmaC Upgrade

More
6 years 11 months ago #149999 by EW_CNC
Error after PlasmaC Upgrade was created by EW_CNC
Hi,
This is my first time upgrading a working PlasmaC config.
I receive the attached error when I start LinuxCNC.

Attachment not found


Then when I ok it, LinuxCNC opens (axis) and the user buttons are not fully visable.
So far everything else works good.
Do I have something missing?
Thanks
EW

Please Log in to join the conversation.

More
6 years 11 months ago #150023 by phillc54
Replied by phillc54 on topic Error after PlasmaC Upgrade
Did you run the Configurator in upgrade mode?

Edit: If you have a Run In Place installation did you run make to rebuild it?

Please Log in to join the conversation.

More
6 years 11 months ago #150027 by EW_CNC
Replied by EW_CNC on topic Error after PlasmaC Upgrade
I ran the configurator and selected upgrade. From a terminal:

$ python /usr/share/doc/linuxcnc/examples/sample-configs/by_machine/plasmac/configurator.py
From my understanding I do not have Run in Place, my linuxcnc file is user/linuxcnc/configs/. Am I correct?

Please Log in to join the conversation.

More
6 years 11 months ago #150038 by phillc54
Replied by phillc54 on topic Error after PlasmaC Upgrade
Run In Place means you did a git clone then built LinuxCNC, the other type is a package install from the BuildBot.

Both types have the same directory in the users home directory.

Could you post your .ini and .hal files please.

Please Log in to join the conversation.

More
6 years 11 months ago #150040 by EW_CNC
Replied by EW_CNC on topic Error after PlasmaC Upgrade
Attached the files:

Attachment not found

Attachment not found

Attachment not found

Attachment not found

Attachment not found

Attachment not found

Please Log in to join the conversation.

More
6 years 11 months ago #150041 by phillc54
Replied by phillc54 on topic Error after PlasmaC Upgrade
Can you start LinuxCNC from a terminal and see if there are any errors as it is loading.

Sorry I am i bit slow responding but I am not getting any email notifications for some reason.

Please Log in to join the conversation.

More
6 years 11 months ago #150126 by EW_CNC
Replied by EW_CNC on topic Error after PlasmaC Upgrade
I started from terminal and it gave the same response.
Attached terminal startup:

Attachment not found

Please Log in to join the conversation.

More
6 years 11 months ago #150158 by phillc54
Replied by phillc54 on topic Error after PlasmaC Upgrade
For some reason it is not creating the plasmac_run.cut-type hal pin.

Could you open a terminal and get a directory list:
Code:
ls -al /home/eweaver/linuxcnc/configs/linuxcnc_plasma > dir.txt
and post the dir.txt file as well as a copy of plasmac_run.py from the above directory.

Please Log in to join the conversation.

More
6 years 11 months ago #150160 by EW_CNC
Replied by EW_CNC on topic Error after PlasmaC Upgrade
Attached Files:

Attachment not found

Attachment not found

Please Log in to join the conversation.

More
6 years 11 months ago #150161 by phillc54
Replied by phillc54 on topic Error after PlasmaC Upgrade
Can you load a GCode file after LinuxCNC loads without it giving that error?

Please Log in to join the conversation.

Time to create page: 0.138 seconds
Powered by Kunena Forum