Configurator Error

I just updated this afternoon before I made a new axis config.

Can you check the last version number in versions.html, it should be v0.87 - 2020 Jan 04

For a Buildbot install it will be:
For a Run In Place install it should be:
It definitely works here.

Yessir that’s the version I’m on.

And the configurator is shown as updated today.

And I 4x checked I ran it from that location.

Just ran it again, same error

Are you trying to change the mode before you select an ini file?

Yes as it’s the top item...

It cannot change the mode when it doesn't don't know what it is yet.

I will change it around.

phillc54 wrote: It cannot change the mode when it doesn't don't know what it is yet.

I will change it around.

Makes perfect sense. Just a work flow thing then.

I’m good at breaking software lol

Thanks for looking into it

I have just pushed a fix for this

rodw wrote: I think its supposed to save some keystrokes for developers becasue it gets away from {} and if..end
But generally if you open a file in a different editor it breaks the indentation...

Always uses spaces, not tabs (but by all means let your editor put in multiple spaces when you press the tab key).
That way there should be no problems.

This is also a general rule for LinuxCNC code, though some files do contain the evil tabs.